Icom IC-V8 Instruction Manual

Also see for IC-V8: Instruction manual Instruction manual Service manual Service manual

5613OPTIONAL UNITD Optional UT-108 installationq Remove the optionalconnecter access cover(named 2251 OPTsheet).• Insert a screwdriver intothe hollow of the chassis,then lift and take awaythe cover. (The covercan not be used again.)WARNING!NEVER attempt to remove the optional connector coverusing your finger nails, this may result in injury.w Attach the optional unit. Insert the connector tightly to avoid abad contact.e Remove the paper back-ing of 2251 OPT sheetsupplied as an acces-sory.r Attach the new 2251OPT sheet to the servicewindow.t Program the necessaryinformation from thetransceivers key pads orusing the cloning soft-ware, before operation.5512 CLONINGCloning allows you to quickly and easily transfer the programmedcontents from one transceiver to another transceiver; or, data froma PC to a transceiver using the optional CS-V8 CLONING SOFTWARE.D Transceiver-to-transceiver cloningq Connect the OPC-474 CLONING CABLE withadaptor plugs to the [SP] jack of the master and sub trans-ceivers.• The master transceiver is used to send data to the sub transceiver.w While pushing [A•FUNC] + [Y], turn power ON to enter cloningmode (master transceiver only— power ON only for sub trans-ceiver).• “CLO N E” appears and the transceivers enter the clone standbycondition.e Push [PTT] on the master transceiver.• “CL” appears in the master transceiver’s display and two digit num-bers show that data is being transferred to the sub transceiver.• “CL IN” appears automatically in the sub transceiver’s display andtwo digit numbers show that data is being received from the mastertransceiver.r When cloning is finished, turn power OFF, then ON again to exitcloning mode.D Cloning using a PCPlease refer to the HELP file that comes with CS-V8 CLONINGSOFTWARE.NOTE: DO NOT push the [PTT] on the sub transceiver duringcloning. This will cause a cloning error.AT POWER ONqwer

/ 34

Related manuals for Icom IC-V8