13 SCAN OPERATION13-4■ Scan (Continued)D When a signal is receivedWhen a signal is received, the scan pauses for approxi-mately 10 seconds (default), then resumes.The scan resumes approximately 2 seconds (default)after the signal is disappears.To manually resume the scan, rotate [DIAL].• These settings can be changed in the MENU screen.(p. 16-18)(MENU > Scan > Pause Timer)(MENU > Scan > Resume Timer)D Scan nameA desired name can be assigned to each PROGRAM-CH (**A/**B). (p. 12-10)By selecting the scan name, the scanning frequencyrange will be set.D Scan Stop Beep functionThe Scan Stop Beep function sounds a beep when asignal is received.The function can be turned ON in the MENU screen.(p. 16-90)(MENU > Sounds > Scan Stop Beep)D Scan function during Dualwatch opera-tionWhen the scan function is used during the dualwatchoperation, the SUB band audio signal may be muted,depending on the operating band or mode.And, the audio output may be interrupted when the fre-quency or operating mode is switched while scanning.❍ SUB band mute statusMAIN band SUB bandDV mode DV modeFM-N modeFM-N mode DV modeFM-N modeAIR band AIR bandScan name“Scan 0”The scan type selecting screen.The S-meter shows thereceived signal strength.BlinksBlinksMAINbandSUBbandExample: Full scan is running on the MAINband, and the AIR band is selectedon the SUB band.When an AIR band frequency isscanned on the MAIN band, theSUB band audio signal is muted.
