13 SCAN OPERATION13-9■ Memory scanRepeatedly scans all programmed Memory channels.There two types of scan in the memory mode; Memoryscan and memory bank scan.• Channels set as “PSKIP” or “SKIP” are skipped duringa scan.• Two or more memory channels, which are not setas skip channels, must be programmed into start amemory scan.D Memory (skip) scanThe memory channels set as “PSKIP” or “SKIP” skipchannels are not scanned.q Push [M/CALL] one or more times to select theMemory mode.w Hold down [SCAN] for 1 second.e Push D-pad() to select the scan type.• ALL : Full scan• BAND : Band memory scan• MODE : Mode memory scan• DUP : Duplex scan (p. 13-2)(Appears only when duplex is set on the chan-nel.)• TONE : Tone scan (For tone scanning)D-pad( )(Ent)r Push D-pad(Ent) to start the scan.• If desired, rotate [DIAL] to switch the scanning directionduring a scan.• The scan resumes even while the MENU screen is dis-played.t To cancel the scan, hold down [SCAN] for 1 sec-ond.• Pushing [CLR] also cancels the scan.TIP: Holding down [SCAN] and then rotating[DIAL] also selects the scan type. The scan immedi-ately starts when [SCAN] is released.Hold down [SCAN]for 1 second.When a signal is received.Memory channelnumber[DIAL]Push [M/CALL] .BlinksBlinksBlinksBlinksThe S-meter shows thereceived signal strength.Push D-pad() toselect, then pushD-pad(Ent).
