13 SCAN OPERATION13-5■ VFO scanThere are 6 scan types: Full scan, Band scan, Programscan, Program link scan, Duplex scan and Tone scan.NOTE: The frequencies that are set as skip channels“PSKIP” are skipped during a scan.When the “PROGRAM SKIP” item in the MENU screenis set to OFF, the frequencies that are set as skip chan-nels “PSKIP”, are not skipped during a scan.(MENU > Scan > Program Skip)D VFO mode scanq Push [V/MHz] to select the VFO mode.w Push [MODE] to select the operating mode.e Hold down [SCAN] for 1 second.r Push D-pad() to select the scan type.• ALL : Full scan.• BAND : Band scan.• P-LINK0~9 : Program link scan.• P00~24 : Program scan.• DUP : Duplex scan (p. 13-2).( Appears only when duplex is set.)• TONE : Tone scan.(For tone squelch scanning)D-pad( )(Ent)t Push D-pad(Ent) to start the scan.• ALL : The decimal point and “ALL” blinks.• BAND : The decimal point and “BND” blinks.• P-LINK0~9/P00~24: The decimal point and Scan edge number blink.• DUP : The decimal point and “DUP+”/“DUP–” blink.• If desired, rotate [DIAL] to switch the scanning directionduring a scan.• If desired, push [MODE] to change the operatingmode during a scan.• The scan resumes even while the MENU screen is dis-played.y To cancel the scan, hold down [SCAN] for1 second.• Pushing [CLR] also cancels the scan.TIP: Holding down [SCAN] and rotate [DIAL]also selects the scan type. The scan immediatelystarts when [SCAN] is released.Hold down[SCAN]for 1 second.Example: Full scan in the FM mode.When a signal is received.[DIAL]BlinksBlinksThe S-meter shows thereceived signal strength.BlinksBlinksPush D-pad() toselect, then pushD-pad(Ent).
