Jenn-Air ELECTRIC WALL OVEN Use And Care Manual

Also see for GAS COOKTOP: Instructions Use & care guide Use & care guide Use & care guide Service manual

29PROBLEM SOLUTIONTROUBLESHOOTINGOven baking results are less • The pans being used may not be of the size or material recommended for bestthan expected. results. (See “Cooking Made Simple” booklet).• There may not be sufficient room around sides of the pans for proper air circulationin the oven.• Check instructions for preheating, rack position and oven temperature.Baking results differ from • Oven thermostat calibration may differ between old and new ovens. Follow recipeprevious oven. and use the directions in this guide before calling for service since the calibration onthe previous oven may have drifted to a too high or too low setting. (See page 20 -Temp Adjust.)Fan is heard when oven is • This is the cooling fan and is normal. The fan will continue to run after useturned on. until the oven cools. (See page 12.)Cooling fan continues to • This is normal. The fan will automatically shut off when the oven has cooled.operate after the oven has beenturned off.Probe does not work. • Check to be sure probe plug is properly inserted into oven receptacle.(select models) • Probe may not be positioned in food properly.• Probe temperature may have been improperly set.• Food may have been too cold or frozen when the probe was inserted.Fault Codes • The oven may detect a fault during programming or during operation. If a fault isdetected, the message “Fault detected - press power to clear” or “Fault detected -press enter to try again” may appear. Follow directions in the display. If the faultreappears or does not clear, call an authorized servicer or the toll-free number in thedisplay.• If the same operation is attempted before having the wall oven repaired, the message“Feature not available” will appear. The feature will remain inoperable until serviceis obtained.• If the oven is heavily soiled, excessive flareups may result in a fault code duringcleaning. Press the CANCEL pad and allow the oven to cool completely, wipe outexcess soil, then reset the clean cycle. If the fault code reappears, contact anauthorized servicer.There are no beeps and • Oven may be in Sabbath Mode. (See page 21.)no display.Noises may be heard. • The oven makes several low level noises. You may hear the oven cooling fan goingon and off. You may also hear the oven relays as they go on and off. These are allnormal.• As the oven heats and cools, you may hear sounds of metal parts expanding andcontracting. This is normal and will not damage your appliance.