Jenn-Air ELECTRIC WALL OVEN Use And Care Manual

Also see for GAS COOKTOP: Instructions Use & care guide Use & care guide Use & care guide Service manual

5Entering the day of the week:1. Press Setup pad.2. Select Clock.3. Select Day.4. Select Back or Fwd to scroll through the days.5. Select Set.6. To exit the Setup mode, press Setup.Canceling the clock/day of week display:1. Press Setup pad.2. Press Clock.3. Press the Down arrow to scroll to the next screen.4. Select Disable.5. Select Off to turn the clock display off, or select On to turnthe clock display on.6. Select Set.7. To disable the day of week display, select OFF or select ONto turn the weekday display on.8. Select Set.9. To exit the Setup mode, press Setup.To set the clock for a 12 or 24 hour format:The clock can be set to display time in either a 12 hour or 24hour format.1. Press the Setup pad.2. Select Clock.3. Use the down arrow to scroll to the next screen.4. Select 12/24 Hr.5. Select 12 Hr or 24 Hr.6. Select Set.7. Press Setup to exit Setup mode.TimersSetting the Timers (Timer 1 or Timer 2):1. Press Timer 1 or Timer 2.2. Select Time.3. Press one of the displayed times using the Quickset pads,or press the number pads to enter the desired time.Changing the amount of time entered once theTimer starts:1. Press the Timer 1 or Timer 2 pad ONCE.2. Press the displayed times on the Quicksetpads until the desired time is entered.OR3. Press the number pads to enter the new desired time.4. Press Enter.Canceling the Timer:1. Press the Timer 1 or Timer 2 pad TWICE.OR2. Press the Timer 1 or Timer 2 pad ONCE andPress CANCEL on the Quickset pads.Changing the Timer format:The Timers can be set to display hours and minutes (HR/MN)or minutes and seconds (MN/SEC).1. Press the Setup pad.2. Select the Down arrow andscroll until you see Timer Format.3. Select Timer Format.4. Select HR/MN or MN/SEC.5. Select Set.6. Press Setup to exit Setup mode.Changing the Timer beeps:The signal beeps for Timer 1 and Timer 2 can be changed.The options available are two beeps every thirty seconds, twobeeps every sixty seconds or 1 beep only. The default settingis One Beep.1. Press the Setup pad.2. Select the downarrow to scroll down until “Tones” is displayed.3. Select Tones.4. Select Timers.5. Select the desired timer beep format (2-30 sec., 2-60 sec.or 1 Beep).6. Select Set.7. Press Setup to exit Setup mode.O VEN C OOKINGNote: Each press of the displayed time choices addsadditional time. For example, pressing “10 min” three timesprovides 30 minutes on the timer (0:30).4. Press Enter.