Jenn-Air JGRP430WP00 Use & Care Manual

Also see for JGRP430WP00: Installation instructions Installation instructions

Contents

Replace Oven Bake Burner Cover1. Align rear shoulder screw mounting holes (keyholes) on theoven bake burner cover with shoulder screws in the bottomof the oven.2= Drop cover and slide to left or right to slide shoulder screwsinto narrow ends of keyholes and lock in place.A. Bakeburner cover3. Replace the oven door. See "Oven Door" in the "Range Care"section.A. Rear shoulder screw mounting holes (keyholes)B. Shoulder screwsIMPORTANT: Before cleaning, make sure all controls are off and the oven is cool. Always follow label instructions on cleaning products.Soap, water and a soft cloth or sponge are suggested first unless otherwise noted.STAINLESS STEEL (on some models)Do not use soap-filled scouring pads, abrasive cleaners, CooktopPolishing Creme, steel-wool pads, gritty washcloths or abrasivepaper towels. Damage may occur, even with one-time or limiteduse.Rub in direction of grain to avoid damaging.Cleaning Method:• Stainless Steel Cleaner and Polish Part Number 31462 (notincluded):• Liquid detergent or all-purpose cleaner:Rinse with clean water and dry with soft, lint-free cloth.PORCELAIN-COATED GRATES AND CAPSFood spills containing acids, such as vinegar and tomato, shouldbe cleaned as soon as the cooktop, grates and caps are cool.These spills may affect the finish.To avoid chipping, do not bang grates and caps against eachother or hard surfaces such as cast iron cookware.Do not reassemble caps on burners while wet.Do not clean in the Self-Cleaning cycle.Do not clean in dishwasher.Cleaning Method:• Nonabrasive nylon scrub pad and mildly abrasive cleanser:Clean as soon as cooktop, grates and caps are cool.COOKTOP CONTROLSTo avoid damage to the cooktop controls, do not use steel wool,abrasive cleansers or oven cleaner.To avoid damage, do not soak knobs.When replacing knobs, make sure knobs are in the Off position.Do not remove seals under knobs.NOTE: When replacing knobs after cleaning either the surfaceburner controls or the griddle module control, make sure theknobs are replaced to the correct location. The 20,000 Btu/hburner knobs have power settings and the griddle knob hastemperature settings. All other knobs have Hi, Med, Lo settingsonly.Cleaning Method:• Warm, soapy water:Pull knobs straight away from control panel to remove.OVEN DOOR EXTERIORCleaning Method:• Glass cleaner and a soft cloth or sponge:Apply glass cleaner to soft cloth or sponge, not directly onpanel.• All-Purpose Appliance Cleaner Part Number 31682(not included):See "Assistance or Service" section to order.SURFACE BURNERSSealed Burner modelsSee "Sealed Surface Burners" section.30