Kenwood KRF-X7775D User Manual

Also see for KRF-X7775D: User guide Connection and setup guide Service manual

Contents

13Chapter One : Connecting Your DevicesConnectionsConnecting Your Cable TV or Satellite Tuner, continuedDo not plug in the receiver or devices to AC power untilyou have connected all your devices.This section focuses on the connections from your cable orsatellite tuner to the KRF-X7775D. Please refer to yourtuner’s instructions for more detail about its connectionjacks and capabilities.The instructions in this section show one of several pos-sible variations on connecting your tuner. For further assis-tance on optional configurations, contact your cable or sat-ellite provider.The VR-5080 is not equipped with VIDEO4 jacks.To Connect a Cable TV Tuner with aComposite (RCA) Video Output:1. Review the information under “Before You Begin” onpage␣ 1. It contains important notes about the types ofvideo connections you can make.2. Connect the audio and video cables from the cabletuner’s Audio and Video OUT jacks to the receiver’sVIDEO2 or VIDEO3 PLAY IN jacks as shown to the left.When the component video cables are connected, theaudio and video cables of the cable TV tuner should beconnected to the VIDEO3 jacks of the receiver.3. If your cable TV tuner and TV have the COMPONENTVIDEO jacks, you can also connect them as shown on theleft.4. Go to “Noting Your Devices” on page␣ 3 and note whichjack you used to connect your tuner. In addition, notethe brand name and model number of the tuner.To Connect a Cable TV Tuner without aComposite (RCA) Video Output:1. Connect the audio cables from the cable tuner’s AudioOut jacks to the receiver’s VIDEO2 or VIDEO3 PLAYIN jacks as shown to the left.2. Leave the cable tuner’s video out (RF jack) connecteddirectly to your VCR or TV (wherever you already haveit connected).3. Go to “Noting Your Devices” on page␣ 3 and note whichjack you used to connect your tuner. In addition, notethe brand name and model number of the tuner.To Connect a Satellite Tuner:1. Review the information under “Before You Begin” onpage␣ 1. It contains important notes about the types ofvideo connections you can make.2. If your satellite tuner has a digital output jack, connecta digital cable between the satellite tuner’s digital out-put jack and the receiver’s VIDEO2 or VIDEO3 digitalinput jack as shown in the figure on the left.3. Connect the audio and video cables from the satellitetuner’s Audio and Video out jacks to the receiver’sVIDEO2 or VIDEO3 PLAY IN jacks as shown to the left.Note that the jack sets are linked, even though they arenot adjacent. You must connect all of the cables fromyour satellite receiver to a linked jack set. For example,if you connect the analog cables to VIDEO2 and thedigital optical cable to VIDEO3,␣ your satellite receiverwill not work correctly.When the component video cables are connected, theaudio and video cables of the satellite tuner should beconnected to the VIDEO3 jacks of the receiver.4. If your satellite tuner and TV have the COMPONENTVIDEO jacks, you can also connect them as shown on theleft.5. Go to “Noting Your Devices” on page␣ 3 and note whichjack you used to connect your tuner. In addition, notethe brand name and model number of the tuner.When playing Dolby Digital or DTS-encoded software inmultichannel configuration, the connected audio signalshould be the digital signal.