29Chapter One : Connecting Your DevicesConnectionsConnecting Your Laser Disc Player (without AC-3 RF Output), continuedDo not plug in the receiver to AC power until you haveconnected all your devices.These instructions describe how to connect a laser disc playerwith a PCM Digital Output. If your player has a Dolby Digi-tal (AC-3) RF Out, see “Connecting Your Laser Disc Player(with AC-3 RF Output)” on page␣ 26. This configuration doesnot allow Dolby Digital laser discs to be played. Please re-fer to your laser disc player’s instructions for more detailabout its connection jacks and capabilities.The instructions in this section show one of several pos-sible variations on connecting your laser disc player. Forfurther assistance on optional configurations, contact thestore where you purchased your receiver.To Connect a PCM Digital Output LaserDisc Player:1. Review the information under “Before You Begin” onpage␣ 1. It contains important notes about the types ofvideo connections you can make.2. Connect the audio cables from the laser disc player’sAudio OUT jacks to the receiver’s AUDIO jacks (VIDEO3PLAY IN)as shown to the left.3. Connect the video cable from the laser disc player’sVideo OUT jack to the receiver’s VIDEO PLAY IN jackas shown to the left.Note that the jack sets are linked, even though they arenot adjacent. You must connect all of the cables fromyour laser disc player to a linked jack set. If you connectthe analog cables to VIDEO2 and the digital cable toVIDEO3,␣ your laser disc player will not work correctly.4. Connect the digital cable from the laser disc player’sdigital jack to the appropriate digital jack on the receiveras shown to the left.5. Go to “Noting Your Devices” on page␣ 3 and note whichjacks you used to connect your laser disc player. In ad-dition, note the brand name and model number of thelaser disc player.When playing DTS-encoded software in multichannel con-figuration, the connected audio signal should be the digi-tal signal.
