76Moving AroundTroubleshootingWith a Dolby Digital program or DTS program, the loud soundsaren’t very loud and the quiet sounds aren’t very quietCheck that volume extremes are not automatically being balanced. See“Midnight Theater Function” on page␣ 16 of this manual.All I hear is loud static when I play DTS discs• Check that Digital has been set as the input mode. DTS discs do notoutput analog sound. See “Switching Input Modes” on page␣ 23.• DTS discs can only be played in Zone AI hear a hum when I select the PHONO inputCheck that:• The audio cables are connected securely to the Phono jack set. SeeChapter One of the Connections and Setup Guide.• The turntable is grounded on the receiver. See Chapter One of theConnections and Setup Guide.Sound is intermittentAttach the provided protective cap to the unused OPTICAL inputs. If thelight from a fluorescent lamp or direct sunlight enters through this con-nector, the played audio will be intermittent.I can’t hear any sound in Zone BCheck that:• Multiple Zones is activated.• The volume in Zone B is turned up. See “Operating Devices in ZoneB?” on page␣ 55 of this manual.• The Zone B speakers are turned on if using Speaker B outputs forZone B (as opposed to Second Zone Pre Outs). See “Turning the Speak-ers On” on page␣ 9 of this manual.• The source is connected via an analog jack set (digital inputs are notsent to Zone B). See Chapter One of the Connections and Setup Guide.VideoI can’t see the program I’m playing on the TV. There wasn’t anyvideo output to my VCR when I recorded• Check that the video source and TV are connected via the same typeof connectors (For VR-5080).Sound / Video
