78Moving AroundTroubleshootingReceiver/TunerI want to clear all the items in Remote Control unit and make it tothe factory-set default condition.1. Remove the batteries.2. While holding the (function up) button and buttonsimultaneously, load the batteries.After the above, all settings are reset to the factory settings.The RF remote control function does not work.• Connect the antenna. See page 33 of the Connections and Setup Guide.• Make sure that the correct RF band is selected. See page 43 of theConnections and Setup Guide.• The operation range of the Remote Control unit will be influencedaccording to the material of the obstacles between the Remote Con-trol unit and the receiver. Please confirm that there is no such influ-ence.• Make sure that no interference from electrical appliances occurs.Receiver/TunerMy receiver won’t turn on and the STANDBY indicator is flashingYour receiver is in the “protection” mode.Check that:• The speaker system’s impedance is not too low. See Chapter One ofthe Connections and Setup Guide.• The speaker wires are not short-circuited. Test the wires as follows tofind the shorted wire and replace it:1 Turn off the receiver, disconnect the positive and negative speakerwires of the RIGHT FRONT speaker from the receiver, and turnthe receiver back on.2 If the STANDBY indicator stops flashing, replace this wire.3 If the STANDBY indicator does not stop flashing, turn off the re-ceiver, reconnect the speaker wires, and repeat the first step for thenext speaker.4 Continue until you have isolated and replaced the shorted wire.5 See Chapter One of the Connections and Setup Guide.
