Kenwood NXR-1700 Function Reference

Also see for NXR-1700: Instruction manual Instruction manual Instruction manual Service manual Instruction manual

15 POWER SUPPLY MONITOR / 15.3 Warning by Warning Tone202FUNC (E)/ Ver 2.0015.3 Warning by Warning ToneIf Power Supply Monitor becomes active, transmitting a warning tone warns a user that the voltage of the repeateris reduced.A warning tone is transmitted for 5 sec upon lapse of 500 ms after Power Supply Monitor becomes active.The transmitted warning tone can be configured as desired.Figure 15-1 Warning ToneNote Because the warning tone is transformed by the vocoder if a warning tone is transmitted on digital channel, thewarning tone may not be transmitted with the originally configured tone frequency, and the tone frequency mayslightly drift from the original tone frequency. The deviation for a warning tone cannot be adjusted individually. The following is the volume when a warning toneis transmitted:Analog: Applies the deviation for a test tone.Digital: The fixed value A warning tone is transmitted even if Power Supply Monitor becomes active while transmitting. However, thetransmission of a warning tone is suspended while a CW ID or CW message is being sent. In this case, thetransmission of a warning tone starts when the transmission of various signals ends. If Power Supply Monitor becomes active while a test tone is being transmitted, the test tone transmission endsand a warning tone transmission starts. No warning tone is transmitted even if Power Supply Monitor becomes active while TX Disable is enabled. Also,transmission of a warning tone ends if TX Disable becomes enabled while a warning tone is being transmitted.Configuration using KPG-D7 Configuring Warning Tone ( Edit > Optional Features > Common Page 2)