Kenwood NXR-1700 Function Reference

Also see for NXR-1700: Instruction manual Instruction manual Instruction manual Service manual Instruction manual

1 FUNCTIONS AND PANEL LAYOUT / 1.3 OLED display31FUNC (E)/ Ver 2.00The operations when editing Network Information are explained.When the Knob is pressed after Edit is selected in NetworkInformation, the selection menu shown to the left is displayed.1. By pressing the Knob while Host IP Address is selected,migration to the Host IP Address edit screen occurs.2. By pressing the Knob while Subnet Mask is selected, migrationto the Subnet Mask edit screen occurs.3. By pressing the Knob while Default Gateway is selected,migration to the Default Gateway edit screen occurs.4. By pressing the Knob while Save is selected, the combination ofthe edited Host IP Address, Subnet Mask, and Default Gatewayconfigurations is checked, the error is displayed when there is aproblem, and the configurations are saved and reflected if thereare no problems.5. By pressing the Knob while Cancel is selected, edits arediscarded and the Network Information display is restored.Example of the Host IP Address editscreenHost IP Address edit screen/ Default Gateway edit screenHost IP Address and Default Gateway are configured in the rangefrom 1.0.0.0 to 223.255.255.255.However, the following addresses cannot be configured:・ 127.***.***.***・ 128.000.***.***・ 191.255.***.***・ 192.000.001.***・ 223.255.255.***Configuration is done in order from the 1st octet for Host IPAddress and Default Gateway.・ The value of the selected octet is changed by rotating theKnob.・ Selection migrates to the next octet by pressing the Knob.・ If an unavailable address is selected, it is skipped or adjusted.・ By holding the Knob while the 2nd octet or later is selected, the1st octet can be restored again.