Kenwood TK-860G Service Manual

Also see for TK-860G series: Instruction manual Instruction manual Service manual supplement Service manual Service manual

Contents

10TK-860G/862G Busy toneSounds in conventional mode, when busy channel lock-out is functioning. You can select yes or no for the optionalfeature's warning tone. Group call toneSounds when a group call with the correct DTMF/2-toneoption signalling is received, repeats 7 times. You can se-lect yes or no for the optional feature's warning tone. Individual call toneSounds when an individual call with the correct DTMF/2-tone option signalling is received. You can select yes or nofor the optional feature's warning tone. Key press tone [A]Sounds when a key is pressed. For toggle keys, soundswhen toggle function is turned on (key press tone [B]sounds when it is turned off). You can select yes or no forthe optional feature's control tone. Key press tone [B]Sounds when a key is pressed. For toggle keys, soundswhen the toggle function is turned off (key press tone [A]sounds when it is turned on). You can select yes or no forthe optional feature's control tone. Key input error toneSounds when a key is pressed but that key cannot beused. You can select yes or no for the optional feature'swarning tone. Roll over toneSounds in Conventional format at the smallest group/channel. You can select yes or no for the optional feature'scontrol tone. Transpond toneSounds when an individual call with the correct DTMF/2-tone option signalling is received. For group calls, only thegroup tone will sound, not the transpond tone. Pre alert toneSounds prior to the TOT TX inhibit activation. If TOT prealert is set, the tone sounds at the amount of time pro-grammed, before the TOT expires (TOT time – TOT pre alerttime = Pre alert tone sounding time). You can select yes orno for the optional feature's warning tone.OPERATING FEATURES / REALIGNMENTREALIGNMENT1. ModesUser modePanel test mode(TK-860G only)PC modeFirmware program-ming modePanel tuning modeData program-ming modePC test mode PC tuning modeSelf programmingmode (TK-860G only)Check sumClone modeMode FunctionUser mode For normal use.Panel test mode Used by the dealer to check the funda-ment characteristics.Panel tuning mode Used by the dealer to tune the radio.PC mode Used for communication between theradio and PC (IBM compatible).Data programming Used to read and write frequency datamode and other features to and from the radio.PC test mode Used to check the radio using the PC.This feature is included in the FPU.See panel tuning.Firmware program- Used when changing the main programming mode of the flash memory.Clone mode Used to transfer programming data fromone radio to another.Self programming Frequency, signalling and features writemode to the radio.2. How to Enter Each ModeMode OperationUser mode Power ONPanel test mode [SCN]+Power ON (Two seconds)PC mode Received commands from PCPanel tuning mode [Panel test mode]+[SCN]Firmware programming mode [CH ]+Power ON (Two seconds)Clone mode [ ]+Power ON (Two seconds)Self programming mode [A]+Power ON (Two seconds)3. For the Panel Test Mode (TK-860G only)Setting method refer to ADJUSTMENT.3-1. For the Panel Tunning ModeSetting method refer to ADJUSTMENT.