Kenwood TK-860G Service Manual

Also see for TK-860G series: Instruction manual Instruction manual Service manual supplement Service manual Service manual

Contents

13TK-860G/862G9. Channel Setting ModeEach channel can be setup in its action mode by usingthe panel keys.• Pressing [MON] when "SELF" is diaplyed, sets channelsetting mode.• Select an item set using [ ] then change the selectionwith the [CH / ].• The data displayed using [D/A] is stored in the memoryand then proceeds to the next item.• Pressing [ ] proceeds to the next item without storing itin the memory.• Press [MON] to set the display to "SELF" and return toreset (default) status.The setup items fro channel setting mode are listed be-low.No. Function Choices Display RemarksSelect 1~128 __1-__1._ [ ] : Group selection/channel __1-128._ Channel selectionSelect 1~128 __1.-__1_ changegroup 128.-__1_1 RX Step STP__250 Display when an itemfrequency 2.5kHz~1MHz STP_1000 is selected or when astep is changed(about 0.5 seconds)[A] : Step change2.5, 5.0, 6.25kHz,1MHz stepBlank - - - - - - - - [ ] : Frequency on/100.0000~ R.100.0000 blank switching550.0000MHz The rightmost dotindicates 50Hz digit(On=5, Off=0)2 RX Off - - - - - - - - [ ] : Off/QT/DQTsignalling QT 67.0~250.3Hz QT__67.0_ switching(EIA mode) QT_250.3_ [A] : Mode switchingQT 67.0~250.3Hz QT__67.0* [SCN] : Normal/(0.1Hz step mode) QT_250.3* Inverse switchingDQT 000~777 DQT000N*(Normal) DQT777N*(1 step mode)DQT 023~754 DQT023N_(Normal) DQT754N_(Standard table mode)DQT 000~777 DQT000I*(Inverse) DQT777I*(1 step mode)DQT 023~754 DQT023I_(Inverse) DQT754I_(Standard table mode)REALIGNMENTIC502TX-RX unit B/2Foil side5051IC5051845 D507D505Fig. 3Note :This mode (self programming mode) cannot be set whenit has been disabled with the FPU.[D/A][D/A][ ][D/A][MON][CH/ ]Radio typeChannel setmode Function setmodeSelf programming modePortable MobileRadio band &channel type VHF8CH VHF128CH UHF8CH UHF128CHFrequencyversion[CH / ][CH/ ] [CH/ ][CH/ ]VHFF1 VHFF2 UHFF1 UHFF3[CH / ][CH/ ][CH/ ] [CH/ ]UHFF4[CH/ ][ ]Cannot beset whenportable isselect.Cannot beset whenmobile isselect.** **8-2. Model Select Mode• Flow chartNote :If the radio type of TK-860G was temporally set to "Por-table" for the cloning purposes, "UNPROG" is displayed (atUser mode) when the TK-860G is turned on.In this case, please set the radio type back to "Mobile" atmodel select mode menu.The silk screen of D505 and D507 is reversed on the TX-RX unit PCB (Part No. J72-0678-02). this silk screen will becorrected from the next version, J72-0678-12.