X-W320 (En)1 71 Stop the tape transport.To stop recordingTo re-start recordingIn stop mode During recordingPauseTo pause recording temporarilyHow to provide non-recorded blanks between programs8¶The following procedure is useful when you want to cancel recording in progress and re-start it.A non-recorded space of about 4 seconds or more should be reserved before the position where recording was started.8¶4 Press the ¶ key once.3 Replay the tune you wish to record.8¶2 Press the ¶ key twice.1 ¡1 ¡2 372 Stop playing the source component.8¶ 8¶Press successively twice.To resume recordingPress once.÷ A non-recorded space of about 4 seconds is reserved on tape, then thetape transport stops.Blank of 4 sec. or more.Recorded tune Re-recordingTune to be re-recorded.Tape stops after 2 sec.of transport.÷ If there is no recorded tune before, the tape will be rewound thenstopped.÷ When re-recording from the beginning of tape, feed the leader tape (thefirst portion of tape that cannot be recorded) before starting re-recording.During recording in the 2 direction:During recording in the 3 direction:How to record (Deck B only)1 Rewind during recording. ÷ When the ¡ (or 1) key is pressed during recording, recording isaborted and tape is rewound as shown below if there is a non-recordedspace of more than 4 seconds before the recording start position.÷ Recording starts.÷ After leaving a non-recorded blank of about 4 seconds, the deck entersthe record-pause mode.8¶÷ The 8 indicator lights.