X-W320 (En)2 31 Insert a tape in deck B.2 Determine the recording condition.1 Select the recording mode.3The “CCRS function” can be used to start recording by setting the optimum recording level for the recorded CD automatically.Please note that the edit recording (CCRS) is not possible with an LD player.Press the CCRS key.How to cancel CCRS÷ For the tape direction setting, see the description below “Select thetape transport direction”. !CCRSREV.MODEDOLBY NRNotesNotes2 Select the Dolby NR mode.1. If the CCRS key is pressed during CD playback, playback stops and CCRS operation begins.2. If the remaining amount of tape is small, CCRS may not function correctly or CCRS operation may be canceled in mid-operation.3. Once the CCRS recording level has been set, the recording balance and recording level cannot be adjusted while the CCRS operation isbeing carried out.4. The CCRS function sets the peak level for the entire CD in approx. 20~200 seconds. On very rare occasions, however, the function maynot be able to set the optimum recording level. If this occurs, carry out recording manually referring to the “Ordinary recording” section.^5. With CD players equipped with the EDIT function, it is possible to make recordings in which the last songs on sides A and B are not cutoff in the middle and in which the recording capacity of the tape is used to the fullest extent. (Set the REV.MODE key of the deck to “[”.)During recording level setting:Press the Stop key of the CD player or the stop keyof the cassette deck.During CCRS recording:Press the Stop key of the CD player, then press theOPEN / CLOSE key of the CD player.After completion of CCRS recording:Press the OPEN / CLOSE key of the CD player.Preparation 1 (Set the input selector key of theAV CONTROL CENTER to CD.)2 (Load a disc in the CD player.)3 (Edit tracks as required on the CD player.): Keys and control used in the operations described on this page.Synchro playback/recordingRecording of CD playback (CCRS) (Deck B only)÷ After recording, the cassette deck and CD player enter the stop modeautomatically.÷ Program-edit recording is not possible when tracks of more than oneCD are programmed using a Carrousel type CD player.÷ The CCRS indicator blinks, and actual recording starts in about 20 to 200seconds (after creating a non-recorded blank of about 8 seconds).Each press switches the indication.1 “[” :Double-side recording.2 “”” :(Tape also stops after having recorded both sides.)3 ““” :One-way recording.Each press switches the indication.1 DOLBY NR “OFF” (extinguished): Dolby NR is not used.2 DOLBY NR “B”: Noise reduction of the ordinary type.3 DOLBY NR “C”: Noise reduction with higher performance.÷ Select the Dolby NR mode according to the tape recording status.