X-W320 (En)1 8Tape dubbing operation (Deck A \Deck B)To stop dubbingPress the 7 key of Deck B.To pause dubbingStart dubbingThe dubbing refers to the copy of the recorded contents ofa tape to another tape (tape in Deck A \ tape in Deck B).DUBBINGNORM. HIGH DUBBINGNORM. HIGHDUBBINGNORM. HIGH DUBBINGNORM. HIGH1. The recording balance and recording level cannot be adjusted for dubbing.2. The DOLBY NR is not active during dubbing.The tape recorded by dubbing features the same NR system as the original tape in Deck A.3. Noise from TV may interfere with dubbed sound if high-speed dubbing is executed near a TV set. To prevent this, install the system fartherfrom the TV set.4. If the original tape was recorded at a high level, the sound quality may be degraded, if high-speed dubbing is used. In such a case, usenormal-speed dubbing.NotesNotesFor normal-speed dubbing. For high-speed dubbing.For normal-speed dubbing. For high-speed dubbing.DUBB. HIGHDUBB. HIGH lights up.DUBB. NOR.DUBB. NOR. lights up.: Keys and control used in the operations described on this page.Normal dubbing:Dubbing at the normalspeed.High-speed dubbing:Dubbing at about twice thenormal speed.2 37÷ Both decks A and B enter the stop mode.÷ Only deck B enters the record- pause mode after leaving a non-recorded space of about 4 seconds in case of normal-speed dubbing,or about 6 seconds in case of high-speed dubbing.÷ To resume dubbing after pause, press the same DUBBING key asabove (NORM. DUBBING or HIGH DUBBING) again.Preparation 1 Load the tape to be played in deck A andthe tape to be recorded in deck B.2 Set the tape transport directions of decksA and B to the same direction ( by press-ing 2 or 3 then pressing 7 immediatelyafter it ).