Keysight Technologies 81133A User Manual

Also see for 81133A: Getting started guide User guide

Contents

Setting Up a Clock Signal Setting Up Generic and Advanced SignalsKeysight 81133A/81134A Pulse Generator User’s Guide, April 2015 31Using the Graphical User InterfaceFirst Steps Before you start:1 Put the instrument into operation.2 Protect the DUT by disconnecting the channel outputs first.Do this by pressing the softkey next to the following function:The open contactor shows you that your DUT is nowdisconnected.Instrument Settings To set the instrument parameters:1 In the instrument panel, choose the Pulse/Pattern mode.2 Switch to Freq and then with the numeric keypad enter 200 asthe magnitude of the frequency.3 Select the desired unit MHz by pressing the correspondingsoftkey.Channel 1 Settings To set the channel parameters for channel 1:1 Switch to the Channel page.Per default, channel 1 is selected.2 Select the pattern mode Square.In the Timing panel, the following parameter are set as default:– The Delay is set to 0 ps.– The DCycle is set to 50%.– The Deskew is disabled.3 In the Levels panel:– Switch Ampl to High and set High to 1.0 V.– Set Low to 0 V.