Setting Up a Repetitive Burst Signal Setting Up Generic and Advanced SignalsKeysight 81133A/81134A Pulse Generator User’s Guide, April 2015 57Reconnect the DUT Enable the outputs:Generated Signal Use the pulse generator’s TRIGGER OUT to trigger a scope.To set up the trigger output:1 On the Aux page, in the Trigger Output panel:– Select the trigger mode Pulse.One trigger pulse occurs at the start of the repetitive datapattern.– Set the Ampl to 1 V.– Set the Offset to 0 V.– Set the Divider to 256.2 Enable the trigger output.The Aux page looks now as follows:
