Setting Up a Burst Signal Setting Up Generic and Advanced SignalsKeysight 81133A/81134A Pulse Generator User’s Guide, April 2015 49The instrument panel now looks as follows:Channel Settings for the PRBS Signal To set the channel parameters:1 Switch to the Channel page.2 Set the signal mode to RZ.3 In the Timing panel:– Switch from Dcycle to Width and set the Width to 100 ps.– Set the Delay to 50 ps.4 In the Levels panel, set:– The level format to Custom.– Amplitude to 2.0 V.– Offset to 0.0 V.5 Enable the Channel 1 normal Output:By pressing the respective softkey in the user interface:– OR –By pressing the normal Out softkey for channel 1 next to theOutput port.Burst RepetitionInstrumentMode
