Setting Up a Data Pattern Setting Up Generic and Advanced SignalsKeysight 81133A/81134A Pulse Generator User’s Guide, April 2015 436 Enable the Channel 1 normal Output:By pressing the respective softkey in the user interface:– OR –By pressing the normal Out softkey for channel 1 next to theOutput port.The Channel page now looks as follows:Channel Settings for thePattern SignalTo set the channel parameters for channel 2:1 Switch to Channel 2 by pressing the Ch2 softkey .2 Switch to the Channel page.3 Select the pattern mode Data.4 Select the signal mode NRZ.5 In the Levels panel, select the predefined level format ECL.This automatically sets:– the Amplitude to 800 mV– the Offset to –1.350 V– the Term. Voltage to –2.0 VPattern ModePRBSPRBS PolynomeSignal ModeECL Levels
