Makita DLS110 Instruction Manual
Also see for DLS110: Instruction manualInstruction manualInstruction manualInstruction manualInstruction manual
                                                                                                                                                                                                                                                    | |
34 ENGLISHState of abnormality Probable cause (malfunction) Remedy along with the switch operation ofthe tool. the tool. into the tool.Install the wireless unit correctly. + the slot is dirty.Gently wipe off dust and dirt on the terminal of thewireless unit and clean the slot. tool has not been pushed.$ < =sure that the wireless activation lamp is blinkingin blue. & [%K ][ Set the stand-by switch on the vacuum cleaner to[%K ][ More than 10 tools are registered to thevacuum cleaner.Perform the tool registration again.If more than 10 tools are registered to the vacuumcleaner, the tool registered earliest will be cancelledautomatically. registrations.Perform the tool registration again.No power supply Supply the power to the tool and the vacuumcleaner. from each other (out of the transmissionrange).Get the tool and vacuum cleaner closer each other. X X -mately 10 m however it may vary according to thecircumstances.Radio disturbance by other applianceswhich generate high-intensity radiowaves.Keep the tool and vacuum cleaner away from theappliances such as Wi-Fi devices and microwaveovens. tool's switch trigger is not pulled.Other users are using the wirelessactivation of the vacuum cleaner withtheir tools. tools or cancel the tool registration of the othertools.MAINTENANCEWARNING: Always be sure that the tool isswitched off and batteries are removed beforeattempting to perform inspection or maintenance.Failure to removing the batteries and switch off thetool may result in accidental start up of the tool which WARNING: Always be sure that the blade issharp and clean for the best and safest perfor-mance.% + may cause kickback and result in a serious personal NOTICE: Never use gasoline, benzine, thinner,alcohol or the like. Discoloration, deformation orcracks may result.Adjusting the cutting angle but rough handling may have affected the alignment. Ifyour tool is not aligned properly, perform the following:Miter angleLower the handle fully and lock it in the lowered positionby the stopper pin. Push the carriage toward the guidefence. Loosen the grip and the screws which secure thepointer and miter angle scale.\Fig.70: 1. Screw on pointer 2. Screws on miterangle scale 3. Miter scaleSet the turn base to the 0° position using the positive ; &; > = ; % !right and left) with the 0° position in the miter anglescale and then tighten the screw on the pointer.\Fig.71: 1. Bevel angle0° bevel anglePush the carriage toward the guide fence and lock thesliding movement by the stopper pin. Lower the handlefully and lock it in the lowered position by the stopper = '| bolt two or three revolutions counterclockwise to tilt theblade to the right.\Fig.72: 1.'|% 2. ScrewZ ; surface of the turn base using the triangular rule, try-; '| = = '| have set.\Fig.73: 1. 2. Saw blade 3. -face of turn baseZ = ; surface once again. Loosen the screw on the pointer.% '| scale and then tighten the screw. |
Related manuals for Makita DLS110
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
Makita DLS110 Instruction Manual
manualsdatabase
Your AI-powered manual search engine