Electra Elite IPK II Document Revision 4CProgramming from a Multiline Terminal 2 - 819Programming from a Multiline TerminalDescriptionSystem Programming can be performed from any display multiline terminal. Most programmingchanges become effective immediately. Other programming changes become effective after the data isbacked up from temporary memory to permanent memory.EnhancementsVersion 1100 or higher provides Temporary Licensing. Features that require a license before they canfunction can be licensed temporarily for up to 10 days. The temporary license turns on ACD, CTI,Firmware Upgrade, Hotel, 256 MEGACO stations, and SMDR.Conditions You can have up to two telephones in programming mode anytime. You can have a maximum of four users logged into WebPro anytime. You can have four WebPro users and two phone programming users logged in at the sametime for a total of six users in programming mode simultaneously. However, the twophone programming users do not show up in session management in WebPro. PCPro can be logged in only with one user. This is only allowed if no other users arelogged into programming mode (PCPro, WebPro, or Phone). Also, if a user is connected tothe switch via PCPro, no other user can log in through PCPro, WebPro, or PhoneProgramming. Programming from a Multiline Terminal can require a password to enter programming. Temporary License can be activated only from a Multiline Terminal, not PCPro or WebPro. When activated, the system is temporarily licensed for ACD, CTI, Firmware Upgrade, Hotel,256 MEGACO stations, and SMDR. Each time the temporary license is activated, the program is read only until the temporarylicense expires. Each time the temporary license expires, it can be set again for up to 10 additional days.EnhancementsVersion 1100 or higher provides a temporary license (10 days) for the following: ACD, CTI, firmware upgrade,Hotel/Motel, 256 MEGACO stations and SMDR.
