Installing the Operating System with Express Setup 5-49IMPORTANT: To specify "Complete Memory Dump" to write the debuginformation is recommended. If the mounted memory size is largerthan 2GB, "Complete Memory Dump" cannot be specified so thatspecify "Kernel Memory Dump" instead. Specify the drive where there is a free area more than the size of"the memory capacity mounted on Express server + 12MB"(In case the memory capacity is more than 2GB, a free area of"2048+12MB" or more). In case the mounted memory size exceeds 2GB due to the addedmemory, change the write debugging information to [KernelMemory Dump] before adding memory. The size of debugginginformation (memory dump) to be taken also changes due toadding memory. Verify the size of the empty space in thedebugging information (memory dump) write destination drive.6. Click [Performance Options].7. Click [Change] on the [Virtual Memory] dialog box.8. Modify [Initial Size] in the [Paging File Size for Selected Drive] box to the value largerthan [Recommended Size], and click [Specify].IMPORTANT: The above-mentioned paging file size is recommended forcollecting debug information (memory dump).The paging file with initial size large enough to store the dump filein the boot drive is required.Correct debug information might not be able to be collected due tovirtual memory shortage when the paging file is insufficient, so setan enough size of the paging file with the entire system. For more information on "Recommended" value, see "PartitionSize to be Created" described earlier. In case the memory is expanded, re-specify the paging file to suitthe new memory size.9. Click [OK].The message to restart the system may appear according to the modified specification.In such case, follow the message to restart the system.
