8-24 TroubleshootingWindows 2000 started with different display resolution from the specified value.→ If the specified display resolution can not be used, the system will use the nearestvalue or the default value of the driver.Entered the incorrect Product ID/CD key.→ Even if you entered the incorrect Product ID/CD key, Express Setup will start.However, the setup will stop and asks you to re-enter the correct value. Also in thiscase, input request will occur when rebooting after GUI setup completed duringExpress Setup. If these 2 inputs are done correctly, there is no problem on Windows2000 setup.Unable to specify the details of Network adapter.→ In Express Setup, you can not specify the details of Network adapter. Specify themfrom Control Panel after starting Windows 2000.Windows 2000 is started with Network adapter that has not been specified during ExpressSetup→ Windows 2000 will install the recognized Network adapter specified as default value.If you want to modify the specification, it can be done from Control Panel afterstarting Windows 2000. Also, the Network adapter that has been specified duringExpress Setup but that is not connected will not be setup, though the protocol willonly be installed.Connected more than two Network adapter and specified different protocol for each adapter,but all the protocols are specified on either adapter.→ It's a design. Each adapter is specified so that all the installed protocols can be used.The value that can not be specified during Express Setup will all be specified bydefault value.When more than two Network adapter are specified, the detailed specification of TCP/IPprotocol are all set to use DHCP.→ When more than two Network adapter are specified, the detailed specification of theprotocol may all be set by default value. Re-specify the details from Control Panel.Not more than two Network adapter is connected, but the detailed specification of the protocolare all set by default.(e.g. Specified IP Address on TCP/IP, but DHCP is specified)→ Are you specifying more than two protocols?In this case, the situation will be the same as connecting more than two Networkadapter, so the detailed specification of the protocol are all set by default.Re-specify the details from Control Panel after starting the OS.
