Installing Windows 2000 F-9Updating the System - Installing Service Pack -IMPORTANT: This system does not support Windows 2000 ServicePack 1 - 3.If you install Windows 2000 CD-ROM which contains Service Pack 4to your system, you do not have to apply Service Pack 4 again.NOTE: If you run the Update of System with the MO deviceconnected, refer following attention.Remove MO media from the MO device immediately after clicking on[Restart Computer].If the message "There is no disk in the drive. ..." is shown during theUpdate of System, click [Cancel] or [Continue] and continue theupdate.To ensure normal system operation you should update your system using the following procedures.1. Logon to the system using the administrator account or other account which is a memberof the Administrators group.2. Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive.Master Control Menu is automatically appeared on the screen.3. Click on [Setup] with left mouse button and click on [Update NEC Express5800 system]section.4. Continue your work for system update as the following message.5. Click on [Restart Computer] to restart the system.6. Remove the NEC EXPRESSBUILDER CD-ROM from the CD-ROM drive immediatelyafter clicking on [Restart Computer]IMPORTANT: If you change the configuration of the system (byadding or removing hardware or Operating system softwarecomponents) or repair the system, you must run the system updateagain.
