5. RAID System ConfigurationExpress5800/R110i-1, T110i-S, T110i Maintenance Guide 173Chapter 2 Useful Features(3) Setting of PriorityLSI Software RAID Configuration Utility displays and sets Rebuild Priority and Consistency Check Priority ofRAID Controller by percentage. However, Universal RAID Utility uses three levels as High/Middle/Low for them.See the table below for correspondence.Setting value of LSI Software RAID Configuration Utility and the display level of Universal RAID UtilityItem Setting value of LSI Software RAIDConfiguration UtilityDisplay level of Universal RAIDUtilityRebuild PriorityRebuild Rate (LSI Software RAIDConfiguration Utility)15 to 100 High8 to 14 Middle0 to 7 LowConsistency Check PriorityChk Const Rate (LSI Software RAIDConfiguration Utility)15 to 100 High8 to 14 Middle0 to 7 LowSetting level of Universal RAID Utility and the setting valueItem Setting level of Universal RAIDUtility Setting valueRebuild PriorityRebuild Rate (LSI Software RAIDConfiguration Utility)High 20Middle 10Low 5Consistency Check PriorityChk Const Rate (LSI Software RAIDConfiguration Utility)High 20Middle 10Low 5Tips LSI Software RAID Configuration Utility can set FGI Rate (ForegroundInitialization priority) and BGI Rate (Background Initialization Priority). ButUniversal RAID Utility cannot set Background Initialization Priority. Initialization Priority cannot be set by Universal RAID Utility in LSI EmbeddedMegaRAID. To set the initialization priority, use LSI Software RAIDConfiguration Utility.
