1. POST Error MessageExpress5800/R110i-1, T110i-S, T110i Maintenance Guide196Chapter 3 Appendix(3) Error messages on a virtual LCDYou can confirm the error messages by the EXPRESSSCOPE Engine 3 (BMC) web browser window. Fordetails, see "EXPRESSSCOPE Engine 3 User’s Guide".The table below shows the error messages displayed on upper and lower lines, cause, and action.If the same error appears even if the action is performed, contact your sales representative. Messages displayed on an upper LCD line(1/2)BIOS Message onUpper LCD Line Description ActionXX POST Started... POST is running. "XX" is the POSTrunning code.This is not an error.XX BIOS Rev YYYY POST is running. "XX" is the POSTrunning code. "YYYY" is the systemBIOS version.This is not an error.POST CompletedSuccessfullyPOST completes normally. This is not an error.POST ERROR XXXX Error XXXX was detected duringPOST.Check the error message which appears on-screen,and take the appropriate action for each error.No AvailableMemory in SystemNo available memory in the server. Make sure that the memory is correctly installed.Error Pause in POST An error occurred during POST. Check the error message which appears on-screen,and take the appropriate action for each error.Entering BIOSSETUP MENURunning BIOS SETUP MENU. This message disappears when SETUP operation iscompleted.Waiting for normaltemperatureA temperature abnormality wasdetected inside the server.Lower the room temperature or turn off the power tocool the server to room temperature before starting upthe server. If this abnormality continues to occur,check if a cooling fan has failed.BIOS RecoveryRunningBIOS recovery is in progress. Wait until the BIOS recovery process completes.BIOS UpdaterRunningBIOS update is in progress. Wait until the BIOS update process completes.Message displayed onupper LCD lineMessage sent from BIOSMessage displayed on lowerLCD lineMessage sent from BMCxxxxxxxxxxxxxxxxxxxx
