2 - 341m or moreƒSlowly (approx. 1m/3 sec.) pull away from center of tube.Looking from side of setSWON / OFFCRTCRTFace the hand degaussing unitso that the longitudinal directionis vertical in respect to the CRT.Do not hold the hand degaussingunit so that the longitudinal directionis parallel in respect to the CRT.Separate at least2cm away from tube.2.9 Degaussing with handy-demagnetizer2.9.1 General precautions(1) Carry this procedure out with the monitor power ON.(2) When degaussing with handy-demagnetizer, the demagnetizer power must be turned ONand OFF at a position at least 1m away from CRT tube.(3) Use a bar type demagnetizer instead of a ring type.Carefully and slowly (1m/3 sec.) demagnetize the CRT tube and bezel side surface.When separating the degaussing coil at the end, separate as slow as possible with thefollowing procedure.If separated quickly, stripes could remain at the picture corners.2.9.2 How to hold and use the handy-demagnetizer(1) Approach the demagnetizer as carefully and slowly (approx. 1m/3 sec.) as possible, andmove around the bezel side periphery two to three times.(2) Next, gradually (approx. 1m/3 sec.) move to the CRT tube side, and move around the CRTtube four to five times with the following procedure.(3) Finally, leave the CRT tube as slowly (approx. 1m/3 sec.) as possible, and turn the handy-demagnetizer unit switch OFF at a position 1 to 1.5m away.(NOTE): The monitor should be degaussed as whichever following conditions.(1) Degauss by handy demagnetizer in off condition.(2) Degauss by handy demagnetizer in power management condition.(3) Degauss by handy demagnetizer with monitor set degauss operation.
