2 - 82.4.4.1 Adjusting the picture inclinationSet the OSD to ROTATE, and using (-) / (+) buttons, set the raster inclination to be horizontalto the CRT face surface.2.4.4.2 Adjusting the back raster position(1) Set BRT to 100% to show the back raster.(2) Adjust the horizontal back raster position to the center of the bezel using H-POSI (VR5A1).At this time, the raster width will be |L1-L2| ≤ 2.0mm.2.4.4.3 Adjusting the left/right distortion, picture width, picture position (H-PHASE) andvertical linearity (all preset)(1) Confirm that DOWN / UP adjustment bar in User mode is at approximately center.(2) Adjust the vertical size to approx. 297mm, and the vertical position to the approximatelycenter.(3) Select VERTICAL and VERTICAL BALANCE in LINEARITY with the OSD, and adjust sothat the vertical linearity is equal at the very top of the picture, at the very bottom of thepicture, and at the center of the picture.(4) Select DOWN / UP and SHORT / TALL with the OSD, and adjust the vertical width andvertical position to the specified values using (-) / (+) buttons.(5) Select IN / OUT, LEFT / RIGHT, PCC-CENTER, TOP and BOTTOM with the OSD, andadjust the vertical line at both side of the picture to the straight line using (-) / (+) buttons.(6) If the left and right distortions differ, select PIN-BALANCE, TILT, TOP-BALANCE andBOTTOM-BALANCE with the OSD, and adjust so that the distortions are visually balanced.(7) Select LEFT / RIGHT of OSD group USER2 with the OSD, and adjust the horizontal rasterposition to the center of the picture using (-) / (+) buttons.(8) Select NARROW / WIDE with the OSD, and adjust the horizontal raster width to the valuegiven in the adjustment list using (-) / (+) buttons. (Refer to 2.5.1.10 Adjustment value list.)* Note (1) PCC-SINE and PIN-BALANCE are used only for touch up.* Note (2) The picture position and distortion must be within the ranges given in thepicture performance inspection items. (Refer to 2.5.1.8 Picture distortion.)Adjustment itemPicutre inclinationAdjustment mode/setFactoryImput signal/patternNo. 12:106.25K / 85Hz, 1600x1200Crosshatch with frameStatusindicatorBack rasterL1 L2Adjustment itemBack raster positionAdjustment mode/setFactoryImput signal/patternNo. 25:85Hz, 1800x1350Only the sync. signal inputStatusindicator
