NEC LCD Monitor Manual 

Also see for LCD Monitor: Control guide

Contents

NEC LCD Monitor Manual  Manual pdf 97 page image

(97/137)19.2 Auto Tile Matrix CompleteThis command is used in order to notify complete status of Auto Tile Matrix Setup.1) The monitor notifies that Auto Tile Matrix completed to controller.Header Message Check code DelimiterSOH-'0'-Monitor ID-'0'-'A'-'0'-'A'STX-'C'-'A'-'0'-'3'-'0'-'2'-ST-ETX BCC CRHeaderSOH (01h): Start of Header'0' (30h): ReservedMonitor ID: Specify the Monitor ID of which you want to change a setting.Ex.) If Monitor ID is '1', specify 'A'.'0' (30h): Message sender is the controller.'A' (41h): Message type is "Command".'0'-'A'(30h, 41h): Message length (10bytes)MessageSTX (02h): Start of Message'C'-'A'-'0'-'3'-'0'-'2' (43h, 41h, 30h, 33h, 30h, 32h): Auto Tile Matrix Complete'0'-'2' (30h, 32h): NotifyST: Error StatusNo Error : 00h (30h, 30h)Error : 01h (30h, 31h)ETX (03h): End of MessageCheck codeBCC: Block Check CodeRefer to the section 4.5 “Check code” for a BCC calculation.DelimiterCR (0Dh): End of packet2) The controller replies to the monitor.Header Message Check code DelimiterSOH-'0'-'0'-Monitor ID-'B'-'0'-'A'STX-'C'-'B'-'0'-'3'-'0'-'2'-ST-ETX BCC CRHeaderSOH (01h): Start of Header'0' (30h): Reserved'0' (30h): Message receiver is the controller.Monitor ID: Indicate a replying Monitor ID.Ex.) When this byte is set to ‘A’, replying monitor’s ID is ‘1’.'B' (42h): Message type is "Command reply".'0'-'A'(30h, 41h): Message length (10bytes)MessageSTX (02h): Start of Message'C'-'B'-'0'-'3' (43h, 42h, 30h, 33h): Auto Tile Matrix Command'0'-'2' (30h, 32h): NotifyST: Error StatusNo Error : 00h (30h, 30h) *FixedETX (03h): End of MessageCheck codeBCC: Block Check CodeRefer to the section 4.5 “Check code” for a BCC calculation.