5-56 Installing the Operating System with Express Setup Create Team1. Open the [Device Manager].2. Open [Network adapters] → [Intel(R) xxx] properties.3. Click [Teaming] tab and check the [Team this adapter with other adapters] check box.Click [New Team].4. Fill the name of the team in [Specify a name for the team] and click [Next].5. Include the adapter to the team and click [Next].6. Select a team mode, and then click [Next].IMPORTANT: Following team types are supported. Adapter Fault Tolerance Adaptive Load Balancing Static Link Aggregation Switch Fault Tolerance7. Click [Finish].8. Click [TEAM: "Team name"] from [Device manager] → [Network adapters] to modifythe team.Click [Settings] tab and click [Modify Team] button.9. Refer to the following procedure to set the team member adapter priority status.– Set PrimaryPoint the adapter and click [Set Primary] button.– Set SecondaryPoint the adapter and click [Set Secondary] button.NOTE: Adapter priority config can be confirmed by the followingprocedure:1. Click [TEAM: "Team name"] from [Device manager] → [Networkadapters].2. Click [Settings] and confirm Adapters in team list.10. Click [Test Switch] → [Run test] to confirm the adapter team is properly setup.Confirm the result in [Test results]11. Restart the system.
