E-24 Installing Windows Server 2008DRIVER INSTALLATION AND ADVANCED SETTINGSThis section describes on how to install and setup various standard drivers mounted on the device.For the information on installing and setting up the driver that is not described in this section, pleaserefer to the document attached to the driver.LAN Driver and PROSetPlease refer to Chapter 5 "Installing and Setting Device Drivers" for Windows Server 2008 to installand setup LAN driver and PROSet.Graphics Accelerator DriverIf you utilize standard graphics accelerator drivers, update your system with NECEXPRESSBUILDER DVD-ROM attached to your system.Standard graphics accelerator drivers will be installed automatically.NOTE: The graphics accelerator driver is supported only on a server running afull installation. Use VGA on a server running a Server Coreinstallation.Please follow the following procedure when you want to reinstall the driver individually.1. Insert the NEC EXPRESSBUILDER DVD-ROM into the optical disk drive.If the autorun menu is displayed, close menu screen.2. Click Start menu, point to [Programs], [Accessories] and click [Windows Explorer].3. Run "Install.bat" in the following directory.– Windows Server 2008 64-bit (x64) Edition:\017\win\winnt\ws2008x64\video– Windows Server 2008 32-bit (x86) Edition:\017\win\winnt\ws2008\video4. Follow the message to continue the installation.If the dialog message "Digital Signature could not been found." appears, select [Yes] tocontinue.5. Remove the NEC EXPRESSBUILDER DVD-ROM from the optical disk drive, restart thesystem.
