9-58 Upgrading Your Server12. After inserting the riser card, firmly press on it with your fingers to connect it.13. Install the components you removed previously.14. Verify that POST displays no error messages.If POST displays an error message, take a note on the message and see the POST errormessages listed on page 371.15. Run the BIOS SETUP utility and select "Yes" for [Advanced] → [Reset ConfigurationData].This setting is required to update the hardware configuration information. See page 275for details.RemovalRemove a PCI card in reverse order of the installation steps. After removal, use the [Boot] menu ofthe BIOS setup utility to set the boot order (as described on page 299).Installing RAID ControllerTake the following steps to install the optional RAID controller in the RAID Controller slot.If using an optional RAID controller (N8103-129/130)For a detailed description, see the instruction manual that came with your optional RAID controller(N8103-129/130).IMPORTANT: The optional RAID controller is an electroniccomponent that is extremely sensitive to static electricity. Beforehandling the controller, touch the metal frame of the server or groundyourself in some other way to discharge static electricity from yourbody. In addition, do not touch the terminals of the RAID controllercard with your bare hands or place the card on a desk without anythingto protect it. Details about static electricity are provided on page 195.NOTE: When inserting an optional RAID controller, on the
