2-28 General DescriptionNotes on handling the Flash FDD Do not turn off the server while the access LED of the Flash FDD is blinking.Turning off the server at this time can cause a failure or data corruption. The Flash FDD is a consumable.→ If the Flash FDD causes an error, use a new Flash FDD. The Flash FDD cannot be connected by way of a USB hub.Directly connect the Flash FDD to a USB connector of the server. Before touching the Flash FDD, discharge static electricity from your body by touching anearby metal object (such as a doorknob or aluminum frame). Do not disassemble the Flash FDD. Do not apply a strong force to the Flash FDD. Do not place the Flash FDD in an area directly exposed to sunlight or near a heater. Do not handle the Flash FDD while eating, drinking, or smoking. Also, be careful not toget thinner, alcohol, or other corrosive substances on the Flash FDD. Be careful when connecting the Flash FDD to the server. Do not move the server or Flash FDD while the Flash FDD is inserted into a server USBconnector. Doing so might cause a Flash FDD failure. After using the Flash FDD, disconnect it from the server.
