NEC PlasmaSync 42XM2 Operation Manual

Also see for PlasmaSync: Brochure & specs

Contents

NEC PlasmaSync 42XM2 Operation Manual Manual pdf 10 page image

3Rear View/ Terminal BoardA AC INConnect the included power cord here.B EXT SPEAKER L and RConnect speakers (optional) here. Maintain the correctpolarity. Connect the (positive) speaker wire to theEXT SPEAKER terminal and the (negative)speaker wire to the EXT SPEAKER terminal onboth LEFT and RIGHT channels.Please refer to your speaker’s owner’s manual.C VIDEO1, 2, 3 (BNC, RCA, S-Video)Connect VCR’s, DVD’s or Video Cameras, etc. here.VIDEO1 can be used for Input or Output (see page10).D AUDIO1, AUDIO2, AUDIO3These are audio input terminals.The input is selectable. Set which video image to allotthem from the audio menu screen.E DVD1 / HD1Connect DVD’s, High Definition or Laser Discs, etc.here.F RGB2/ DVD2/ HD2RGB2: You can connect an analog RGB signaland the syncronization signal.DVD2/ HD2: You can connect DVDs, HighDefinition sources, Laser Discs, etc.here.This input can be set for use with anRGB or component source. (see page24)G RGB1 (mini D-Sub 15pin)Connect an analog RGB signal from a computer, etc.here. This input can be used for Input or Output. (seepage 10)H RGB3 (DVI 24pin)Connect a digital signal (TMDS) from a source with aDVI output. (see page 8)I EXTERNAL CONTROLThis terminal is used when operating and controllingthe monitor externally (by external control).J REMOTE INConnect the remote cable* to the remote control’sremote jack to obtain wired remote control.K REMOTE OUTConnect the remote cable* to the REMOTE IN jack ofthe other display monitor to obtain wired remotecontrol.* The 1/8 Stereo Mini cable must be purchased separately.VIDEO(IN/OUT)VIDEO 1VIDEO 2VIDEO 3AUDIO 1 DVD1 / HD1R( MONO)LY Cb/Pb Cr/PrRGB2 / DVD2 / HD2 RGB 1R/VDG/ B/HD (IN / OUT) DV I ( Digital RGB )AUDIO 2R( MONO)LAUDIO 3R( MONO)LCr/Pr Y Cb/PbRGB 3A BDCEFGHIJKExternal ControlIN OUTREMOTE