NEC PlasmaSync 42XM2 Operation Manual

Also see for PlasmaSync: Brochure & specs

Contents

NEC PlasmaSync 42XM2 Operation Manual Manual pdf 42 page image

35Loop Out settingWhen this feature is set to ON, the received signal will belooped out.Example: Setting “ON”Set “ADVANCED OSM” to “ON” in the main menu (1/2), then perform the following operations.1. On the MAIN MENU, select “OPTION3”, then pressthe MENU/ENTER button.The “OPTION3” screen appears.2. Use the and buttons to select “LOOP OUT”.3. To set the LOOP OUT to “ON”...Use the and buttons to select “ON”.The mode switches as follows each time the or button is pressed:OFF ↔ ONOPTION3 3 / 3EXITPREVIOUS PAGETIMERPWR. ON MODECONTROL LOCKIR REMOTELOOP OUTID NUMBERVIDEO WALL: LAST: OFF: ON: ON: ALLSEL. RETURNADJ.Information LOOP OUT settingsON ...... The received signal will be looped out via PC1terminal or VIDEO1 terminal.OFF .... The received signal will not loop out.* Even if LOOP OUT is ON, signals won’t be sent out ifPOWER is being turned off. To connect another display...See page 10. If the RGB/PC1 signal is present at the timethe power switched on...The RGB/PC1 input will be displayed regardless of thesetting of LOOP OUT. Restoring the factory default settingsSelect “ALL RESET” under the OPTION1 menu. Notethat this also restores other settings to the factorydefaults.ID number settingWhen using more than one of these displays, this functionsets ID numbers so that operation of the remote controldoes not cause multiple monitors to operate at the sametime.Example: Setting “2”Set “ADVANCED OSM” to “ON” in the main menu (1/2), then perform the following operations.1. On the MAIN MENU, select “OPTION3”, then pressthe MENU/ENTER button.The “OPTION3” screen appears.2. Use the and buttons to select “ID NUMBER”.3. To set the ID NUMBER to “2”...Use the and buttons to select “2”.The mode switches as follows each time the or button is pressed:→ALL ↔ 1 ↔ 2 ↔ ..... ↔ 255 ↔ 256←OPTION3 3 / 3EXITPREVIOUS PAGETIMERPWR. ON MODECONTROL LOCKIR REMOTELOOP OUTID NUMBERVIDEO WALL: LAST: OFF: ON: OFF: 2SEL. RETURNADJ.* To reset back to ALLPress the CLEAR button.Information ID NUMBER settingsALL ........... ID NUMBER will not be set.1 to 256 .... ID NUMBER will be set. When the ID NUMBER have been setYou can also set ID NUMBER for each remote controlto operate the plasma display individually. To do so,see below. Restoring the factory default settingsSelect “ALL RESET” under the OPTION1 menu. Notethat this also restores other settings to the factorydefaults.To set the ID number for the remote controlExample: Setting “2”1. Press the ID SELECT button on the remote control.The “ID SELECT” screen appears.2. Use the and buttons to select “ID NUMBER”.3. To set the ID NUMBER to “2”...Use the and buttons to select “2”.The mode switches as follows each time the or button is pressed:→ALL ↔ 1 ↔ 2 ↔ ..... ↔ 255 ↔ 256←ID SELECTPOSITION : 1EXIT: 2RETURNADJ.ID NUMBER* To reset back to ALLPress the CLEAR button.4. Once the setting is completed...Press the EXIT button to delete the ID SELECT screen.