NEC PlasmaSync 42XM2 Operation Manual

Also see for PlasmaSync: Brochure & specs

Contents

NEC PlasmaSync 42XM2 Operation Manual Manual pdf 21 page image

14FULL size screenThe image is expanded in the horizontal and verticaldirection.ZOOM size screenWhen wide signals are input.TRUEThe image is true resolution.FULLInformation Supported resolutionSee page 7 of Model Information for details on thedisplay output of the various VESA signal standardssupported by the monitor. “PICTURE SIZE” settingWhen the setting of “PICTURE SIZE” is OFF, the sizeof RGB-input pictures will be TRUE in place ofNORMAL. When 852 (848) dot 480 line wide VGA*signals with a vertical frequency of 60 Hz andhorizontal frequency of 31.7 (31.0) kHz are in-putSelect an appropriate setting for RGB SELECT modereferring to the“Table of Signals Supported” on page 7of Model Information.* “VGA”, “SVGA” and “SXGA” are registeredtrademarks of IBM, Inc. of the United States.Note:Do not allow the displayed in 4:3 mode for an extendedperiod. This can cause a phosphor burn-in.Wide Screen Operation withComputer SignalsSwitch to the wide screen mode to expand the 4 : 3 imageto fill the entire screen.1. Press the WIDE button on the remote control.2. Within 3 seconds ...Press the WIDE button again.The screen size switches as follows:→ NORMAL → FULL → ZOOMNORMAL size screen (4:3 or SXGA 5:4)The picture has the same size as the normal computerimage.FULL size screenThe image is expanded in the horizontal direction.ZOOM size screenWhen wide signals are input.FULL size screenWhen “PICTURE SIZE” is set to “OFF”* This cannot be set in some models. “TRUE size” will notbe displayed in such cases.The screen size switches as follows:→ TRUE → FULL → ZOOMTRUE size screen (VGA, SVGA 4:3)The image is true resolution.