Program 10 : System Configuration Setup10-28 : SIP System Information SetupLevelSADescriptionUse Program 10-28 : SIP System Information Setup to set up basic SIP trunking.Input DataItem No. Item Input Data Default01 Domain NameSet the domain name of the SIP-URL.Up to 64 Characters(ex. : UserID@HostName.DomainName)None02 Host NameSet the host name of the SIP-URL.Up to 48 Characters(ex. : UserID@HostName.DomainName)None03 Transport ProtocolSet the protocol for the connection.0 = UDP1 = TCP004 UserIDUser ID in the SIP Invite Setup message. Use it foroutbound caller ID information if no information isassigned in commands 21-17, 21-19, 15-16, 14-12and 10-36. A call cannot be completed across thespan if there is no outbound CID info. The reasonfor this is: the from and display portion of the invitemessage would be blank, and it would not knowwhere the call originated from.Up to 32 CharactersWhen assigning the User ID, the ID maycontain only alpha characters. (A spaceand/or special characters are not al-lowed in the User ID field).(ex. : UserID@HostName.DomainName)None05 Domain AssignmentIf the information from Telco was a domain name(siptrunk@sip.com) then set to domain. If the infor-mation for Telco was a IP address then set to IPAddress.0 = IP Address1 = Domain Name006 IP Trunk Port BindingTrunk port binding is only used for SIP trunks tothe provider in Non-Registration Mode only. Whenthis is disabled, an inbound call comes in and fol-lows your DID routing but it comes in on the firstavailable trunk. When enabled, the inbound callcomes in and follows your normal DID routing butmaps to that specified trunk. If that trunk is busy, itsends back a busy unless you build a hunt group.To build the hunt group, it references command14-12-02 (pilot register ID). This then points you tocommand 10-36-02. All the numbers with thesame pilot are in the same hunt group.0 = Disable1 = Enable0ConditionsNoneFeature Cross ReferenceNoneISSUE 1.0 SL1000/SL1100Program10Programming Manual 2-33Downloaded from www.Manualslib.com manuals search engine
