NEC SuperScript 1450 User Manual

Contents

NEC SuperScript 1450 User Manual Manual pdf 73 page image

PostScript Level 2 Upgrade 73PRINTER OPTIONSP OST S CRIPT L EVEL 2 U PGRADE(Order No. 1802)Install the PostScript Level 2 Upgrade for computers thatmust send their print jobs as PostScript files. Macintoshcomputers send their print jobs as PostScript files. Windowscomputers send print jobs as PostScript files if they are usingthe Windows PostScript printer driver.Installing the kit involves gaining access to the printerController Board and installing a single PostScript SIMM.To install the PostScript Level 2 SIMM:1. Remove the printer side cover and access the printercontroller board as described on Page 71.2. Position the printer so you have access to the printercontroller board.3. Figure (A) shows the controller board and the location ofthe PostScript SIMM slot.4. Locate the notch on the SIMM (B).5. Position the SIMM into the slot so that the notch is at thebottom (C).6. Snap the SIMM into position (D).7. Use the procedure in Step 1 as guide to replace printerside cover, 500-sheet Cassette tray, and printer cables.8. If not already done, perform the following tasks:•For computers running Windows, install a WindowsPostScript printer driver as described by Chapter 3,“Installing the Software.”•For Macintosh computers, install the LocalTalk andSerial Interface Upgrade as described on xx, thenconfigure your Macintosh as described in Chapter 3,“Installing the Software,” on Page 27.9. Confirm the installation by printing a printerconfiguration page as described on xx.BA DCInstall the PostScript module into the first slotNotchInstalling a PostScript Level 2 UpgradeNow being revised