– 66 –CHAPTER 2 Operations of SV8500 Server5.4.2 Procedure For FP85-104 S1This section explains how to initialize CF card. Performing this procedure, all the contents on the card willbe initialized, leaving BASE System (OS) only installed. Any programs of the system, SVI files, or officedata settings are not to be installed on the card. To install these data to CF card, perform the initial instal-lation by using PCPro Tools after this initialization procedure.Note: Refer to the “Installation Manual”o”CHAPTER 5 SYSTEM STARTUP”o“1.2 Program Install to CFCard” for the initial installation procedures.Note 1: Keyboard will be set up as Japanese keyboard layout.Note 2: Initialization procedures delete all the programs, SVI files, and office data settings from the CF card.Be sure to make backups of these data before performing the following steps.Note 3: Performing the initial installation procedures and executing reboot, LAN1 becomes invalid. Set LAN1by using PCPro Tools.Note 4: During the initial installation procedure, the default IP address of LAN1 is set to 192.168.0.2. Checkthe settings on your PC. After the initial installation process, the default IP address for LAN2 ofSV8500 becomes 172.16.253.0/16. Check the settings on your PC.Note 5: Use DISS command to check the issue information of BASE System (OS). You can see the issue infor-mation of the installer CD-ROM printed on the label as “BASE_SYS:xx.xx”. When you obtain the latestinstaller CD-ROM, compare the version information and decide whether to update the OS or not.Note 6: Do not specify an incorrect device. Doing so will cause a kernel panic. If this occurs, reboot the PC bypower switch.Initialization procedure deletes all the programs, SVI files, and office data settings from the CFcard. Be sure to make backups of these data before performing the following steps.WARNING
