– 187 –CHAPTER 2 Operations of SV8500 Server14. IP DEVICE PC PORT REMOTE CONTROL14.1OverviewThis feature allows the maintenance personnel to disconnect/connect the PC port of the IP Stations from/to the network using PCPro. For example, the maintenance personnel can quickly disconnect the PC (thatis connected to the PC port of IP Station) from the network when virus is detected on the network.14.2Operating ProcedureSee “CPCP command” in Chapter 6.14.3Service Conditions(1) This feature is available for the following terminals:IP Enabled Dterm (Dterm Series i): Ver. 3.06 or laterDtermIP (Proprietary Protocol): Ver. 3.08 or laterDtermIP (SIP): Ver. 3.0.0.0 or laterDT700 Series: Available since first version(2) This feature can be executed while the terminals registered to the System.(3) In the FCCS network, execute this feature on a node basis.(4) The status of the PC port can be saved on a station number basis.(5) The following shows the service conditions only for DtermIP (Proprietary Protocol).(a) PC Port setting is canceled if the DtermIPs (Proprietary Protocol) register to the System again afterthe terminal reset. Therefore, DtermIPs (Proprietary Protocol) needs to be placed in “PC Port shut-down” status after each registration.(b) This feature is not available for DtermIPs which have not yet registered to the System. It is requiredto execute this feature after completing the registration.(c) If this feature data (CPCP command) is set on the terminals in logout status, the set data does not takeeffect even after the terminals log into the System. In this case, the CPCP command data setting isrequired after the registration.(d) To use this feature (CPCP command control), the following configuration setting on the terminal isrequired.• Select “Automatic” from the User Menu o Ether Port Setting o PC Port Settings o Port Available(PC).When “Automatic” is selected:If the software reset is executed, the status of the PC port can be maintained.If the hardware reset is executed after turning off the terminal, the status of PC port is also reset (PCport will be connected to the network).
