– 501 –CHAPTER 3 System Messages36-F: Fusion Health Check Report (Temporary/Permanent)[36-F] Fusion Health Check Report (Temporary/Permanent) is output when the timeout of Fusion Health Checkis detected.This message is of two types: Temporary and Permanent.The temporary failure message is displayed when the timeout of Fusion Health Check is detected. Note 1The permanent failure message is displayed when the timeout of Fusion Health Check has been detected tenconsecutive times.Fusion Health Check is executed by assigning the system data [ASYDL/ASYDN: SYS1, Index 530].Also, the system message [36-F/36-K/36-T] is output when the timeout of Fusion Health Check is detected, byassigning the system data [ASYDL/ASYDN: SYS1, Index 534]. Refer to Office Data Specifications for the de-tail.Note 1: By default, the message is defined to be output at the first timeout; this output timing can be changed bythe system data [ASYDL/ASYDN:SYS1, Index 656, Bits 0-3].Note: While [36-F] Fusion Health Check Report (Temporary/Permanent) has been output for the temporary tim-eout of Fusion Health Check, if Release Alarm is executed, the Error Counter will be cleared. Therefore, ifthe timeout of Fusion Health Check is detected after Release Alarm is executed, the [36-F] Fusion HealthCheck Report (Temporary/Permanent) will be output for the temporary timeout of Fusion Health Check.Also, if Release Alarm is executed when the timeout of Fusion Health Check is detected, [36-K] FusionHealth Check Report (Recovery) will not be output.Note: [36-T] Fusion Health Check Report (Permanent) can be output instead of [36-F] Fusion Health Check Re-port (Temporary/Permanent) for the permanent timeout of Fusion Health Check when the system data[ASYDL/ASYDN: SYS1, Index 655, Bit 0-2 = 1] is assigned, which can be specified on a Fusion type basisas shown on the table below.Note: When [36-F] Fusion Health Check Report (Temporary/Permanent) or [36-T] Fusion Health Check Report(Permanent) is output, if there is no alternate route, a call cannot be made to the node where a failure isoccurring until [36-K] Fusion Health Check Report (Recovery) is output. However, a call can be madewithin the same node or node where a failure is not occurring.Note: When [36-F] Fusion Health Check Report (Temporary/Permanent) or [36-T] Fusion Health Check Report(Permanent) is output, [36-K] Fusion Health Check Report (Recovery) is output when released.Default Alarm Default Grade Grade Modified Lamp ModifiedSUP - -Fusion Type Target Device RemarkP2P External LAN oExternal LANExcept for EtherLink Disconnection
