– 134 –CHAPTER 2 Operations of SV8500 ServerNote 4: When this count is large in number, wrong password may be assigned to either the TP side or SIP ter-minal side. When the TP side or the SIP terminal side of password is corrected, this situation does notoccur. For more information of TP side password, refer to SIP terminal Accommodation [S-146] inData Programming Guide (Windows)-SIP. For SIP terminal side, refer to the operation manual foreach terminal.Note 5: This is the number of situations recognized as no vacancies in bandwidth at SP. When this count is largein number, additional vacant speech channels are needed. The speech channels are added by ASSDN/ASSDL command. Up to 1200 speech channels are provided.9.2 Operating Procedure for PCPro(1) Procedure for Set-up and StartThe procedure to set up and start the traffic measurement is as follows:STEP 1 By using the ASYD/ASYDN command, assign the necessary system data as follows:When performing traffic measurement on a node basis:- ASYDSYS1, INDEX 8 (Number of Tenants) Note 1SYS1, INDEX 9 (Number of Attendant Consoles) Note 1SYS1, INDEX 47, b0 (Unit of Traffic Measurement): 0/1 = CCS/Erlang Note 2SYS1, INDEX 47, b7 (Traffic Measurement Service): 0/1 = Out/In Service Assign “1.” Note 2When performing traffic measurement on a network basis (via TCP/IP):- ASYDNSYS1, INDEX 8 (Number of Tenants) Note 1SYS1, INDEX 9 (Number of Attendant Consoles) Note 1SYS1, INDEX 47, b0 (Unit of Traffic Measurement): 0/1 = CCS/Erlang Note 2SYS1, INDEX 47, b7 (Traffic Measurement Service): 0/1 = Out/In Service Assign “1.” Note 2Note 1: When Station Peg Count, ATTCON Peg Count or ATT Answer Peg Count is performed.Note 2: When Terminal Traffic Measurement, Route Traffic Measurement or Connection Route TrafficMeasurement is performed.STEP 2 By using the ATRF/ATRFN command, assign the traffic measurement programs as follows:When performing traffic measurement on a node basis:- ATRF Note 4Assign traffic measurement TYPE Note 3, PORT number used, and the output INTERVAL andTime (HOUR/MINUTE), etc. For more information, see the ATRF command.When performing traffic measurement on a network basis (via TCP/IP):- ATRFN Note 4Assign traffic measurement TYPE Note 3, PORT number used, and the output INTERVAL andTime (HOUR/MINUTE), etc. For more information, see the ATRFN command.Note 3: Select one measurement TYPE at a time. If two or more measurement TYPEs are needed, repeat thesame steps, following the entry of this command.
