– 891 –CHAPTER 7 Maintenance CommandsMEM_HDD_N: Data Control Between Memory and HDD for Fusion Network1. Functional OutlineThis command, available at the NCN only, is used to save/verify a series of Office Data from the Memory of allLocal Nodes to the Flash Card of each same node.Note: You can install/verify the data onto the Flash Card of all the node on the FCCS network (Maximum 64nodes).2. ParametersInput dataDirection Select: Memory to Hard DiskVerify HDD against MEMData Type Selection: Data Memory Note 1Name DisplayWireless Call ForwardingCall ForwardingSpeed CallingUser Assign Soft KeyNumber Sharing Note 2ACD Data MemoryCall BlockICB and DRExpanded Speed CallingCall Forwarding-LogoutOne Touch Speed Calling for DtermIPMessage Area ID DataSR-MGC DataSIP Terminal Call Transfer Note 4Mobility Access DataDay/Night DataLocal Phone book DataAll Select: Check this box when selecting all the data types listed in the “Data Type Select” field.When individually selecting a specific number of data types, leave the box unchecked(and specify the type(s) in the “Data Type Select” field).LP Select: The parameter is valid when “Call Forwarding”, “Speed Calling”, “User Assign SoftKey”, “Number Sharing”, “Call Block”, “ICB and DR”, “Expanded Speed Calling”,“Call Forwarding-Logout” or “Mobility Access Data” is designated.Auto Verify Afterward: Automatically verify the data after being copied.Auto Scroll: Refresh the Processing Status Log< For “Redundant Data Memory Backup on Individual Hard Drive” > Note 3
