SPLITMUX Quad Screen Video Splitter4MOUNTINGThe SPLITMUX-HD-4RT can be purchased in a 1RU case with parts and hardware for mounting in a rack as a single unit(SPLITMUX-HD-4RT-R) or as a dual unit (SPLITMUX-HD-4RT-2R). Follow the instructions below for assembly and installation.Whether the SPLITMUX will be mounted as a single or a double, brackets will be attached to the case to enable mounting ears ora connector plate to be attached.1. Attach the ear brackets to the SPLITMUX. The holes in the brackets should line up with pre-threaded holes in the sides of theSPLITMUX. Tighten the screws securely.Note: If the ear brackets are applied to the rear, the cable management tray cannot be used.Figure 1- Attach ear brackets to front corners or rear corners.2. If the ear brackets have been applied such that the front will face out, assemble the cable tray to the holes in the rear of theSPLITMUX as shown below.Figure 2- Attach cable tray (if applicable)FYI: The same hole pattern isprovided at the front and rear ofthe ENVIROMUX, enabling theENVIROMUX to be mounted withthe front facing out or rearfacing out.
