SPLITMUX Quad Screen Video Splitter36Command DefinitionsCommand String Good Response DescriptionCS SA,ip,01 * Connect input X to the output portCM SA,mode,01 * Change the mode of the switchCF SA Login Prompt Open Text MenuCB 00,BR NoneChange baud rate of serial line,BR=11(5200),57(600),38(400),19(200)96(00),48(00),24(00),12(00)Factory default is 9600RU SA *IP,OP Read Unit SizeRS SA * Reset unitIf the first field is not a known command (as listed above) or SW field is different from the serial address programmed in the switchmemory, the command will be ignored. If the SW field corresponds to the unit address, but the syntax is wrong after this field, theswitch will answer with a bad response ?.Telnet ControlTo control the SPLITMUX using telnet from the command line, the SPLITMUX must first be connected to the Ethernet.Note: Telnet must be enabled through the web interface (page 18) for a connection via Telnet to be possible.To open a telnet session to the SPLITMUX, Issue the following command from the command line:telnet <SPLITMUX IP address> 2000<SPLITMUX IP address> is IP address of the SPLITMUX (default is 192.168.1.30).The user will be prompted for the root password to connect to the SPLITMUX.The factory default password is "nti". (all lowercase letters).With a proper password sent the SPLITMUX will respond with:Password SuccessfulConnection EstablishedThe commands below are now available.Command String Good Response DescriptionCS,ip,01 * Connect input X to the output portCM,mode,01 * Change the mode of the switchCF Login Prompt Open Text MenuCB 00,BR NoneChange baud rate of serial line,BR=11(5200),57(600),38(400),19(200)96(00),48(00),24(00),12(00)Factory default is 9600RU *IP,OP Read Unit SizeRS * Reset unitNote: When making a Telnetconnection through any terminalsoftware, be sure to configure toconnect through port 2000.
