Nidac 1 Series Instruction Manual
                                    | |
Contents
| 
11The default Manager code is disabled when a new Manager code isprogrammed; it will be enabled again if all programmed managercodes are deleted.The default Lock and Auxiliary codes are disabled when any newcode is programmed; they will be enabled again if all programmeduser codes are deleted.The Default Auxiliary code will also be disabled if the Auxiliary Relayis not set as Lock Control.3.3 USER CODESThere are 3 levels of users codes available in the VST keypads toprovide different access levels, all of these code levels can be used foropening the door. Each code level is described below.3.3.1 ManagersMangers are the highest level codes providing the ability to operate thedoor(s), perform advanced code functions (refer Advanced Codefunctions on page 12) and they allow access to the manager mode toadd and remove user codes.3.3.2 Primary UsersPrimary users are intermediate level codes and can be used to operatethe door(s) and perform advanced code functions (refer Advanced Codefunctions on page 12).3.3.3 Standard UsersStandard users are the lowest level codes and can only be used tooperate the door(s). These codes may also be locked out by theAuxiliary input and/or the Manager and Primary user codes dependingupon options set in the Installer Setting Programming. |
Related manuals for Nidac 1 Series
manualsdatabase
Your AI-powered manual search engine