225 USER CODE PROGRAMMINGUser code programming is performed by entering the manager mode.The factory default manager code is 1111.Note that the default manager code will be disabled once a newmanager code is programmed.To enter manager mode press (the final is not required when using fixed length codes)The keypad will beep 5 times and the Mode LED will be flashing Green To exit manager mode press , the keypad will sound 3 sets of 2quick beeps.The VST keypad will remain in Manager mode for 1 minute from the lastkey press.The keypad will respond with a Warble on successful addition or deletionof a code and with a Long Beep when unsuccessful.In Manager mode the Status LED indicates the conditions below. - Waiting for the start of a programming or exit sequence.Green- Adding a code, waiting for or to be entered.Green- Adding a code, waiting for the new to be entered.GreenRed- Adding a code ( already entered) to a userlocation with an existing code in it. Waiting for new tobe entered to overwrite the existing one.Orange- Adding a code, waiting for the user level digit (, or ) or to be entered.Orange- Adding a code, waiting for the lock output control digit (, or) or to be entered.Red- Deleting a code or exiting manager mode, waiting for location>, or to be entered.Red- Deleting a code by search method ( already entered),waiting for the existing user code to be entered.GreenOrange- Bulk adding user codes.
